View Full Version : blower switch
s10maniac24
06-30-2005, 08:21 AM
my blower for air condition(and heat) only runs on low. i got it to work properly last summer by flicking the switch back and forth a couple times, then it worked fine. now it\'s done the same thing again, but this time i can\'t make it work. i thought it might be a loose/corroded wire, but they look fine. then i thought i might just need a new control switch, but air conditioning/heater controls don\'t illuminate when i turn the headlights on either. any thoughts?
riotpolice75
06-30-2005, 09:28 AM
1. the bulbs in the hvac control burn out or the connector aint hooked up
2. oull the whole assembly out of the dash, its only 2 screws, check the connections. if their burnt or your not sure go to the yard and get a new one.
3. check the resistor pack that plugs into the evaporator housing. its a 4 prong connector and the only thing that is on the housing. check those and the wires goin to it.
thatll keep you busy for a while.
smith
vBulletin® v3.7.4, Copyright ©2000-2010, Jelsoft Enterprises Ltd.