Desktop Dyno this please

[racer1182]

400 sbc

350 carnkshaft

flat top w/4 valve relief psitons

camel hump heads screw in studs and guide plates and full roller rockers and



Edelbrock camshaft 7102

Advertised duration of 308 in 318 ex

dur @ .050 234 in 244 ex

Lobe sep 112





Please let me know how much power this would put out Thanks for any help.



Greg

[s10rodder]

I don\'t have desktop dyno, but whoever does it will probably also need to know:



cam lift (also - mechanical/hydraulic, roller/flat tappet)

intake manifold

carb

compression ratio (or at least combustion chamber cc)

[Truckman91]

373hp @ 5000RPM 405lbft @ 4000 RPM



I had to assume somethings....

[racer1182]

Camel hump heads with a 461 casting

RPM Air Gap intake manifold

600 cfm carb for right npow until I get a 750

cam is .488 in and 510 ex lift and is a Hydraulic flat tappet

full roller rockers with screw in studs, guide plates, and hardened pushrods.



Thank you for the first estimate and see if this info changes anything if you would please Truckman91. Thanks again

[Truckman91]

Doesnt change it noticably. I guessed around .525 lift, and I used a 650cfm carb.

[racer1182]

ok thanks Truckman91, I appreciate it.



Greg

[ChevyKiD_69]

i give you a year and it is blown up...

[racer1182]

yeah ok dude..........this one is gonna get done a little better than the 327 was.it will last a long time this time.only reason the 327 blew is cause I let you drive it..hehehehehehehe

[racer1182]

now if I let mike Gipson build it it wouyldn\'t last 3 monthes.he sucks