Ignition switch help needed

[gbrown85]

Does anyone have a diagram of how the ignition switch plugs are wired. I swapped my steering column to an automatic column shifter. In doing so, 2 wires pulled out and evidently I put them in the wrong socket(s) because I\'m not getting juice to the starter. It will crank and fire with a remote starter switch, but not with the key. If it ain\'t one thing, it\'s another!!

[racer1182]

rae the plugs on ehach the same or did you take the plug off of one to put on the other?. If the same plug is on the other then just see which one it goes to and do it that way if you can. Hope this may help you some.



Greg

Prineville, Oregon

[gbrown85]

The plugs on each were the same. Just had to rotate it because the automatic column ignition switch works just the opposite of the standard column switch. Looking at the old column won\'t help. I tried that.



Two of the wires popped out of the plug and I guess I put them in the wrong slots. This happened about a month ago, so I\'m a bit foggy on which ones pulled out. I\'m trying to figure out the right slots. Thanks

[racer1182]

if you can\'t find a diagram just trace wires back from each part to the switch and see that way but there should be a diagram somewhere

[gbrown85]

Since I really can\'t eplain what I need, here is a picture. The question is, Which wire is in the wrong place? The wiring diagrams do not show the info I need.



http://s10v8.com/members/gbrown85/ignition.JPG

[gbrown85]

Got it figured out. I didn\'t do anything with the clutch switch when I swapped columns and pedals. A wire tie does wonders!