2001 Prostock rolling Chassis ( chromoly)

[Prostock509]

I have a 2001 extended cab chassis engineering Pro stock S-10 with fiberglass body.Set up fpr sand drags right now but can be converted back over in a half hour. I will sell it rolling or with the motor in it. Motor is a 509 cui bowtie block with edlebrock pro performer heads. 13. to 1 compression. 780 hp on gas with a 500 hp pro fogger NOS system. Engine is bullet proof. I have a TCI 2 speed powerglide transmission. Carbonfiber driveshaft, fab 9 rear end with 40 splile gun drilled axles. Strange coilovers,strange disk brakes, funny car cage,autometer ultralight guages,, MSD 7al digital programable ignition box, dual optima batteries, polycarbonate windows, all steel braided fuel and brake lines, line lock, progressive nitrous controller, centerline warrior wheels ..much much more $ 20,000 roller $ 37,000 turn key

http://i269.photobucket.com/albums/jj56/jgotts2003/DSC01349.jpg
http://i269.photobucket.com/albums/jj56/jgotts2003/DSC01348.jpg
http://i269.photobucket.com/albums/jj56/jgotts2003/DSCN0529.jpg
http://i269.photobucket.com/albums/jj56/jgotts2003/DSCN0522.jpg

[Prostock509]

http://i269.photobucket.com/albums/jj56/jgotts2003/DSCN0530.jpg
http://i269.photobucket.com/albums/jj56/jgotts2003/DSCN0528.jpg

http://i269.photobucket.com/albums/jj56/jgotts2003/DSCN0526-1.jpg

http://i269.photobucket.com/albums/jj56/jgotts2003/DSCN0525.jpg

[exxxllr8]

i was wondering where you purchaced the carbon fiber drive shaft.....i also have the extended cab with big horsepower and dont want to use the carrier bearing set up that it came with any info would be great

[rayL]

the motor is moved way back in that truck so i dont think your comparing apples to apples. Regardless, here ya go. http://www.pstds.com/