Need better designed exaust

[lit549]

Any suggestions,i built my own motor mounts so the engine sets lower in the bay,i have angle plug headers that sre 1-1/2 tubes,i want bigger tubes and i want too run fenderwell headers with side pipes,

[XTEN]

Any suggestions,i built my own motor mounts so the engine sets lower in the bay,i have angle plug headers that sre 1-1/2 tubes,i want bigger tubes and i want too run fenderwell headers with side pipes,Sidepipes?Below are pics of my truck when I dragged it outa the mud,it had sidepipes on it.Ghetto Fabulous!You lose alot of turning radius with fenderwell headers on the street.Thats what I wanted,but I talked to Bakas about it,and kinda decided against it.If I just raced it,they'd be on mine.

[lit549]

Yea guess ur right, cause mine will be on the street more than anything,sounded cool though.im just tired of it being so hard too get to the collector bolts.but thats part of having s-10 huh?

[XTEN]

Yea guess ur right, cause mine will be on the street more than anything,sounded cool though.im just tired of it being so hard too get to the collector bolts.but thats part of having s-10 huh?Longtubes make it really easy.6 9/16 bolts right under the front of the doors and its uncapped.

[manyfire]

hey Xten want to sell that grill, how long has that thing been sitting there?

[XTEN]

hey Xten want to sell that grill, how long has that thing been sitting there?Manyfire,it sat right there in the mud for over a decade.I pulled it out of there in 2004.Thats my red truck I just put the motor in.(pictured below)I dont have the grill anymore,but they"re really cheap at Keystone Crash if you have one near you.I think I paid $28.00.The black car sitting next to it is the Mazda I cut the roof off for my sunroof in the S10.

[Queue]

I welded a longer down pipe to the end of my headers so I could reach the nuts on the tail pipe assemblies put drivers side just left of the transmission and again right of the transmission and the passengers side nearly in the same place as the drivers second cross over connection dumped the mufflers out OVER the fram at the rear wheel and down into a pair of Harley balony cut exhaust pipes looks fine and sound nice and throtty deep my next is to figure a way to put a splitter inline on each pipe to dump open a pair of straight pipes right out of the header, just for drivin the little camaros off the street when I want to spread daffy's wings and fly

[Ryoung68]

Nice long bed XTen. :headbang:

[XTEN]

Nice long bed XTen. :headbang:Thanks,Ryoung.Goofyass camera.If I sucked anymore at pics,it'd pull the moon down:o(Its actually a shortbed)