97 blazer brake question

[red1997blazer]

Does anyone have a schematic or know where all the wires go to the electronic brake module.



My abs hasn\'t worked since the swap. So far I found where the front speed sensors go and where on of the wires went to the stock ecm and I hooked it up to the spedo signal and the light will stay out till about 15mph. I also tried connecting that wire to the vss yellow wire and purple wire and the abs light just stays on.



Any imput will be appreciated. I hate letting my girlfriend drive my truck without abs.

[red1997blazer]

any suggestions on what forum I should ask this in?

[largekid]

have you looked in the haynes or chiltens manuals in their schematics? i got rid of my ABS when i did my swap so no help here http://www.s10v8.com/images/smilies/icon_frown.gif

[rayL]

i think your having a wheel speed problem. They dont start reading till 10 mph. At that time the EBCM determines if theres a problem. Why not just get it scanned and see what code its setting. If a lights on then theres a code in it.

[red1997blazer]

where do they scan the abs codes from. And where should I go to get this done?

[red1997blazer]

I have looked in my haynes manual.

[Ryoung68]

Auto Zone will scan for free.

[red1997blazer]

I\'m going to get it scanned on my lunch break today.

[red1997blazer]

They found zero codes. Anyone know of someone on here that has a newer gen S10 with abs and a v8.