selling parts

[hollieandgreg]

i need to sell some stuff to try to recoop some money and get this thing done. i've got 2 sets of 350 heads, don't remember casting #'s, I'll post them later if anyone is interested. 2 stock used oil pans, driver dipstick 2 pc seal. brand new summit chrome pan, pass dipstick 2 pc seal, ordered by accident. 8 stock 5.7" rods but 1 cap missing. a 350 cranks- 1 needs turned, other should polish ok. 1 4 barrell iron intake, 1 2 barrell. box of 4 or 5 quadrajets. its all colecting dust and i'll nver use any of it, stuff might make good home for someone on a tight budget.

[OTHCUSTOMS]

Figured id use this guys post, haha, i have parts to as well. 350 block 30 over. manley main caps. internal balanced forged steel crank, needs to be polished. 5.8 crower rods w/ trw flat top pistons all caps are very new. i rod needs to be replaced.internal balanced fluid damper, internal balanced flywheel. lunati 600 roller cam and roller lifters. all parts were once whole but i broke down the motor due to spinning 1 bearing. nothing is seriously damaged just needs to be polished out. i caught it all in time. will sell whole or in pieces. email me for any questions.

[hollieandgreg]

i get 20% of the profit then right?

[OTHCUSTOMS]

HAHAHHAA

[hollieandgreg]

i also have a set of standard rings.

[Blazin42]

I am interested in the heads, unless they're stock

[hollieandgreg]

both sets are stock iron heads. 1.94, 1.50