Intakes for Dart

[bhstall]

What is a good intake to use with the Dart Iron Eagle Heads.... I have a torker II intake now...but the manifold runner ports are way small... they don\'t mach the heads very well??????

[knudsonm]

I would recomment the Edelbrock RPM Air Gap or a Victor. The RPM Air Gap is the best damn SBC intake out there IMO.

[350-s-10]

i just got the new RPM Air Gap....... i havent put it on yet, but will post how it works when i get it on there, along with my RPM heads and new cam!

[whiner3]

i used a rpm airgap with my e-tec-200 cylinder heads, huge huge power, loved that intake with a mighty demon 725 on it

[cherp22]

I have a set of aluminum pro 1 darts and I have a Victor Jr. It works real well up stairs but still gives good torque.

[Slapperbar]

AIR GAP!!!

[mommasboy]

Vicotr Jr. if you ask me.There is really no limit on how far you can take one of them. A friend of mines camaro with a 406, 11.5:1 comp, AFR 210\'s and a Victor jr. and 750 holley ran 11.48@approx. 118 at 3600ft elevation. Another friends Camaro race car runs mid-high 9\'s (3600ft elev.) all day long with a 406 AFR 190\'s and a Victor jr.

[mouse]

check into the dart intakes.I got pro 1 heads on order and still looking at intakes. P.a.w carries them

[bohn333]

i would go by what cam your running, if its for top end then go with a open plane intake, if its more or less a bottom end cam with good midrange power i would go with an AIR GAP,or an RPM intake. but the torquer II is a good all around intake. Its the best of both worlds. I would run that and see how you like it. the nice thing about Torquer II\'s are there real low profile so it helps with hood clearence issues. And they do make power..there patented for a reason. OH..and if the ports are to small port match them.

[mommasboy]

The Dart CoolCan is supposed to be a good intake too. Have\'nt tried one but the are rated good.