be cool

[cs10v8]

I was woundering if any one has used the all aluminum be-cool radiator? that is what I have and I was whanting to know if some low profile fanes would fit or or what I should use I normally run about 45 to 50 mph to keep it cool. I am still tring to find a fan that will fit with the engine is all the way forword and cant get it any futher back due the the tranny so any help on this matter would help a lot. http://www.s10v8.com/images/smilies/icon_confused.gif

[dell]

I used a fan from a 87 Pontiac Bonneville, I know that the ford Taurus fan is a good choice, I would recommend at least a 16 inch fan and have it pulling.

[snapper]

I tried one once. I had overheating problems with a 350TPI. I live in Texas, overheated with or without the A/C on.



I then did some research and used an 87 corvette rad moved forward 2 inches. I use and 18 fan to keep things cool. This is much cheaper, about $150, than I wasted on the other rad.

[cs10v8]

thanks I\'m going to change it out once I have rebuilt the trans allthough it has only gotten hot once or twice and i\'m in oklahoma