PDA

View Full Version : efans

danteisme
09-29-2002, 09:36 AM
what efans can i use on my 2.2 that i can use on my lt1 when swap time comes around?

i really dont want to have to buy them now and then need to upgrade to another set later on.
Mike
09-29-2002, 04:51 PM
i would recommend at least a 16 inch fan
Trickten327
09-30-2002, 06:30 AM
What rad are you planning on going with??
danteisme
09-30-2002, 07:34 AM
i was thinking about going with a 4.3 radiator or the one in the parts section from here
danteisme
10-06-2002, 02:39 PM
ok, got a new idea. i seen someone had this on their s10. they got their fan from permacool, its a single 14in fan.. \"The 14\" unit I went with puts out 2950 CFM in a pull configuration\". is that enough cfm for a lt1? i know its enough for my 2.2....
4more
10-06-2002, 02:41 PM
i ran a single 14 in not sure of the cfm but it was plenty for mine depends on how much city driving you do
danteisme
10-09-2002, 05:34 PM
ok, i got a new idea. an efan that works for a v8 will work for a 4 banger im assuming. so what efans are you guys running, what do you reccomend?
ZZ4Blazer
10-09-2002, 11:25 PM
Im not sure if it will fit on the 2.2 radiator, but I am running the Flex o lite slimline dual 12\" fans with adjustable thermo # FLX-210. With my 4.3 radiator, 70/30 water mix, 160 thermo, and a bottle of water wetter, I ran down the highway today at 160 degrees\'. I don\'t even think that my fans turned on today. But, it was only 72 degrees outside.
danteisme
10-10-2002, 03:05 PM
what other efans are you guys running that may fit?
schitthedd
10-10-2002, 04:31 PM
Check into the ford taurus fan.
Zoolook
10-10-2002, 10:37 PM
I run a 1 piece, dual fan setup from a 98 Chrysler Concord. Fits the vette radiator like a glove and it`s slim. Pulls some serious air! No clue what cfm they might be though.
MOREPOWER
10-14-2002, 03:00 PM
Does anybody know what a umm 2000 up windstar fans pull? they look like they would fit right into place. with two motors and shield build around it?
BrotherD
10-14-2002, 07:46 PM
I dont know how much air the windstar fans pull. but those dual fans look like a pretty good setup. although most if not all have the LH motor sticking out quite a ways. the LH fan is a lowspeed. the right is a highspeed. but Im sure they could be wired either way. Not for sure.