need help

[Watto]

just need some sugestions on what components to build a motor to turn high rpm and make big horse power. i want to just start with 355 high flow heads big cam single plane manifold. i would like to run about 11.1 compression. just want some suggestions on internals ext.

[gdmclnh]

high rpm and big horsepower = 4 bolt mains, complete forged 4340 steel (crank, rods and pistons) and balanced rotating assembly, assembled with clearances for racing applications. Above is a must for high rpm and high HP engines.

[wild85]

If you don\'t have a crank go with a scat or eagle crank, the cast ones are good for 500+hp or a forged one which is good for a lot more, eagle ibeam rods, arp fasteners for the mains, dart iron eagle heads,or world products sportsman 2\'s, or if you got alot of money AFR makes some decent heads. If you have flat tops and you want 11:1 use 64cc chambers, AFR doesn\'t make that small of chamber though, only 68 or 72 and 76 for all out race.For a cam go with duration @ 0.50 to be around 240 degrees, comp or crane are good. How high do you plan on revving this thing to? Your gonna need a stout combo to rev to 7500 to take advantage of that single plain.Not to mention a big carb.

[Watto]

i was doing some research and i was thinkin of going with dart heads 210cc 68 with i think 2.08 1.60 valves comp magum cam 292 cam demon 850 carb with a eagle crank and eagle i beam rods also wiseco pistons i believe the cam is 501 gross lift i kinda wanted to go with cast iron head but i cant find a company that make a good cast iron head

[Watto]

also thought about going with the holley system maxII engine kit i have herd a couple of motor that had them and they sounded damn good