View Full Version : gauges
ben442
04-29-2004, 08:14 PM
I was wondering if any one has redone there gauges in a 85 blazer. I don\'t like the look of the stock ones and, was wondering if I could take out the seat belt one and replace it with fuel. And the fuel guage with a tach. And does any one have a aftermarket speedo.I would like all the guages to match in the factory pods. Anyone done it?I haven\'t seen any gauge face kits either.
afghanimobilerawks
04-29-2004, 08:41 PM
if you search long and hard enough (took me 6 months!!!!) you may get lucky and find a factory cluster with the small fuel guage and the tachometer. but like i said, they are very hard to come by, and quite rare...
ben442
04-29-2004, 08:46 PM
Thanks, I didn\'t know they came like this. Is there a after market solution?
afghanimobilerawks
04-29-2004, 08:54 PM
no aftermarket that will fit in the stock guage dealy\'s that i have found, but i also didnt look too hard for aftermarket... so if you search you may find one.
redneckgames
04-30-2004, 04:32 AM
You will probably end up doing what I am going to do. Make your own custom panel.
afghanimobilerawks
04-30-2004, 06:43 AM
if you want to buy a new one, youre in luck, i just did some searcing on ebay and found a cluster with tachometer. heres the like for you: cluster with tach (http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=33675&item=2476618 707&rd=1)
ben442
04-30-2004, 07:09 AM
Is the cluster with tach a good buy?
afghanimobilerawks
04-30-2004, 07:29 AM
i personally think so, hence why i bought one, but you may have better luck going aftermarket, because with the tach you have to do some calibration. if you do buy the cluster with the tach, i know that there is a bunch of stuff on this page about calibrating the tach. if you have the conversion manual theres also stuff in tere i beleive. with after market tho, you may have to do a custom cluster, instead of putting it in the stock pods.
DJ-Fla
04-30-2004, 07:07 PM
hey, take a look at my pics, see what i did to an 85 dash
vBulletin® v3.7.4, Copyright ©2000-2010, Jelsoft Enterprises Ltd.