Power Steering Help...

[Dman]

I am stumpped! I have placed an 327 into my S10 and ran into a problem... Since the heads I have dont have accesory mount holes I have had problems with finding a way to mount my power steering pump! I finaly found an lower power steering bracket made by Alan Grove but.... When I went to place the pump on I didnt have any clearance for the pulley due to the gearbox! Has anyone else had this problem? What have you done? Is there a smaller pulley for conversion or does this give it too much P.S.I.?

[LT-10]

Can Ya pst a pic of the Alan Grove setup???

[newsomemichael]

i also run a 327 with the stock head with no accessories holes.I found a stock power steering pump at a swap meet over the summer.Have\'nt put it on yet but it mounts at the bottom of the block i front and come around to the motor mount on the drivers side on the motor..

[360hp350]

I think the old Monte Carlos had a power steering bracket that hooked to the exhaust manifold(correct me if I am wrong). You might look for an older monte setup.