PDA

View Full Version : Tranny/driveshaft?\'s

hotrod
11-30-2002, 02:02 PM
How much of the yoke needs to be sticking out of the trans tailshaft?? I don\'t wanna hit a bump and smash the DS into the output shaft. That would be bad very bad. http://www.s10v8.com/images/smilies/icon_smile.gif

Let me know.

Thanks Brad
Mike
11-30-2002, 02:16 PM
in my opniion, get as much in there as you can!
basementdweller
11-30-2002, 02:58 PM
when i had my driveshaft made the shaft-shop said to put the yoke in all the way, and then pull it out an inch.. and make my measurements... so.. i backed it out an inch.
Wendell
11-30-2002, 05:07 PM
[quote]

On 2002-11-30 18:58, OneSickS10 wrote:

when i had my driveshaft made the shaft-shop said to put the yoke in all the way, and then pull it out an inch.. and make my measurements... so.. i backed it out an inch.



i agree, 1 inch is correct
hotrod
11-30-2002, 07:38 PM
Ok great, sounds good. Thanks for the quick response.

Brad
whiner3
12-01-2002, 12:44 PM
i think it depends on weather it\'s a one peice driveshaft or a two.... the 2 peice driveshaft the front half doesn\'t really move anywhere because of the center hanger... the rear half takes all the movement.... i know on m,y s-10 even from the factory it only had like maybe a half an inch...