MSD 6A

[ZeroGravity58]

I was thinking about picking up a MSD 6A box. But heres my question. I have a almost new Mallory HEI full mechanical advance distributor. Is there a way i can run the box with this? or should i just not even worry about getting one. Or should i just upgrade the parts on my ditributor now?

[ZR1BLAZER]

yah you can run the box with that. it will come with the instructions on how to hook it to almost anything. the only thing is. and i dont know if you care or not but the 6A doesnt come with a rev limiter. the 6AL does and so does the accel 300+ you might want to check out the accel 300+. it is a digital processer and the 6A, and 6AL are both anolog. MSD is still the shit dont get me wrong but digital does think faster then analog.

[ZeroGravity58]

ok i was just checking. My HEI has the incap coil and all. I was just thinking about taking the coil out and putting in the 6A....

Also while im at it....i got my 4.11\'s and posi installed finally. i went from 3.42\'s to 4.11\'s...how much did it throw my Speedo off? right now i dont know how fast im going...haha

[ZR1BLAZER]

not sure about the speedo thing? but you dont take the coil out of the hei. if you look under the cap where the wires go for your ignition hot and tach. behind that is where all the wires are for the coil. that is where you will wire the box to the coil at.

[wild85]

what size tires you got on the back? what tranny? 4.11\'s right. I can figure it out for you if i get more info.

[ZeroGravity58]

i have a 700R4 tranny with 4.11\'s and im running a 255/60/15 tire on the back for now. Thats not bad tho i can get a MSD box for a decent price then i can upgrade to a MSD incap coil or i can use my 50,000 volt mallory one

[ZR1BLAZER]

use the mallory coil.

[ZeroGravity58]

what all would i need to change? nothing just add the box?

[ZR1BLAZER]

just add the box and wire it to the coil. like i said it comes with instructions. if you get it used and doesnt have instructions let me know and i will email them to ya.

[350-s-10]

i have a used one for sale if you are interested... it is hardly used too! complete with instructions and wiring, pm me if interested