Exhaust Wanted

[danksta]

Im looking for used or new exhuast for sale. I have the 350 S10 Headmen headers and I want non cat. collecter back. Please reply if you have any type for sale. $?

[my454s10]

summit-jegs...if you what cheap...those turbo mufflers are like 20.00 each and sound pretty decent for being cheap

[ZR1BLAZER]

are you looking for the exahust system or just mufflers?

[danksta]

Im looking for a ready to weld or bolt up system that doesnt have the Cats. on it. Dual or Single doesnt matter.

[ZR1BLAZER]

i have extra pipe with mufflers but you would have to do all the welding and bending? almost not worth it. you can get straight pipe from summit at a fair price. its the bends that are going to cost ya no matter what.

[spacecadet]

You may want to try to find a shop that will custom bend an exhaust for you. Cost depends on the shops $$$ p/hour and the guy bending the pipes abality. There was some one here who paid big money, there was also a couple here that made thier own.

[BrandOmatic]

I have a full true dual system with cherry bomb mufflers. I think it\'s like 1 7/8\" pipe though. Also it was put in the truck when it had a 400 small block with stock exhaust manifolds, so those ends will probably be bent at the wrong angle and stuff. But it\'s all bent to go around the trans, over to the passenger side, over the rear end, then spreads back out to come out the back even. I don\'t know how i\'d ship this though??



BTW my truck is a reg. cab short bed 2wd. Yours would have to be the same. Probably is?

[ZR1BLAZER]

i tried to ship an exhaust system from my monte carlo ss and even after cutting it down to fit it in different boxes it was still going to be 165 from La to Fl? something to think about.

[BrandOmatic]

yeah that\'s the shitter right there.

[danksta]

Damn it then. The problem I have is no exhuast shops will work on my truck cause you have to have Cats. even though in my county emmissions is not required.

[CHEVY383MAN]

Use the flowmaster collector back exhaust system for a 68 camaro. Thats what I used. You will have to do a little cutting with a sawzall to get the right length because they come a little long. it comes with dual 2.5 mandrel bend H pipe, 2 40 series flowmaster mufflers, exhaust pipes for bothe sides and all the hangers and clamps. I got it from Jegs for about 260.00 with free shipping. If you can cut and weld this is the best way to do it yourself.

[grim_reaper888]

just custom do it. i did i should have a picture uploaded soon.

[BrandOmatic]

there has to be someone who will touch it. It is the same deal around here, but there are a few shops that will do it but won\'t give you a receipt. And i guess their rule of thumb also is that they cannot remove a catalytic converter w/o putting on a new one. however if the vehicle comes to them w/o a catalytic converter installed, they do not have to install one. *shrug*

[racer1182]

that sucks man my shop did mine and al that was on it was headers and collecters with a foot of pipe when i took it it...........where do you live.......maybe take it to another state to have it done

[Ed]

I have exactly what you are looking for. Its listed on the classified board under exhaust. Only bad thing is that I am in Georgia.







complete exhaust (http://www.s10v8.com/classifieds.php?op=viewbizdetails&bid=396)

[jrws6]

get some used cats from a junkyard and have them installed with your exhaust system, then sawzall them off and couple in a filler piece. or you could tell them it wont be used on the street,(race only) but the track rules say that you have to have mufflers.

[danksta]

The only way they will install any exhaust without a cat is that you have to have your registration done for off road use and same with the title.

[racer1182]

that is bs danksta. Just do what Chevy383man said I think that would be your best bet in order to get it done if you have a welder that you can use and a saw zall

[bratass]

Find a completely junked s10 and have the title done as offroad

[Scotty_S-15]

On 2005-01-11 03:55, danksta wrote:

The only way they will install any exhaust without a cat is that you have to have your registration done for off road use and same with the title.



Just tell them to install the cats with header flanges, then you can easily drop them, and either install a piece of straight pipe, or just rod-out the goodies from inside the cats and stick \'em right back up. That\'s what I did, I have 2 sets of cats, one with, one without. http://www.s10v8.com/images/smilies/icon_wink.gif I think you can see that in my pix.

[8yrvipr]

HEY I HAVE A 92 REG CAB SHORT BET WITH

COATED HEADMAN SHORTS AND 2.5 DUALS WITH FLOWMASTERS DUMPED IN FT OF AXLE. I WANT TO GO WITH LONG TUBES. SO I MIGHT BE SALEING IT ALL. SHIPPING CAN BE DONE OTHER WAYS FOR CHEEPER



<font size=1>[ This message was edited by: 8yrvipr on 2005-01-12 11:41 ]</font>



<font size=1>[ This message was edited by: 8yrvipr on 2005-01-12 11:42 ]</font>

[ChevyKiD_69]

tell that guy who has been telling you that you have to have the cats. hes full of crap there is a muffler shop over here in central oregon that told me the same thing then i went to talk to a freind that has had theirs done there. they told me to tell them that it is for a after market type deal. i would call them on bs on it. cause its not factory.

[jrws6]

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=33630&item=7948468 330&rd=1