need help with torsion bars

[BadBowtie]

I have a 1987 s1- blazer 4x4.

I was trying to adjust the torsion bars when the head of the bolt broke off. so in order to fix it i think i need to take the whole crossmember down. But how do i get it off the truck i cant seem to figure out how the torsion bars come out from the cross member. Anyone got some ideas?

[4more]

NO.... dont take the crossmember down

if you look close the bolt that adjust the tortion bar height goes into a small \"nut\" about 1in by 3in rectangle nut. the end of the bolt then pushes up on a piece of steel that the tortion bar goes into. on this piece of steel there is a small divid hole if you will. there is a spacial tool to release the pressure of the tortion bar off of the \"bolt and nut\" you can use a c-clamp to do this also if you move the pivit piece of steel you should be able to remove the broken parts and replace with a new bolt and \"nut\" contact me if i need to explane better

[BadBowtie]

damn too late i already got the crossmember down. i h=gues ill have too put it back and do it your way. by the way your idead is really good, would have never thought about that my self.