Tuned Port Injection with MAF

[TPI]

I need some kind of air intake tube for an 87 iroc Z TPI motor with the mass airflow in it and filter system, installing into 1992 s-10. Only thing keeping my truck off the road. Any suggestions?

[Truckman91]

Any tubing that you can route around and put the MAF and an air filter will work, where do you have room?

[mzoomora]

Airflow online (http://shop.airflowonline.com/Merchant2/merchant.mv?Screen=SFNT&Store_Code=AFSI)

They have some pretty useful stuff. If you are going to run your MAF sensor w/o the screen, keep it in a straight piece of tubing if possible. With a straight section in front of and behind it. When you are ready for a filter go to K&N\'s web site, you can pick out a cone filter by dimension based off of what you have room for.

[TPI]

I have 2\" between the radiator and the pulley system, and no clearence above the throttle body. Have about and inch and a half between top of radiator to hood.

[sorj]

I custom built a cold air intake for mine, maybe you can see in picture. I offset with a drop to the left and connected the MAF on the drop section. It is the aluminum looking piece on top of radiator (shown in picture).

[TPI]

Thanks for the info, even though I had already checked your pic